« previous next »
Pages: [1]   Go Down

Author Topic: Clutch linkage questions  (Read 221 times)

0 Members and 1 Guest are viewing this topic.

Offline invicta65

  • Buick Fan
  • ***
  • Posts: 14
Clutch linkage questions
« on: April 10, 2020, 12:21:43 PM »
does anyone have close up pictures of the linkage parts and the length of of the adjuster parts. Need to know the the length of the threaded rod.
Logged
1965 gran sport ht 3 speed
1968 skylark

Offline jmos4

  • Crazy about Buick!
  • *****
  • Posts: 366
Re: Clutch linkage questions
« Reply #1 on: April 10, 2020, 03:34:15 PM »
Hi,

I  get approximately 2-1/2-3" round section or 3-1/2-4" from hole, this was going from a bent one from a 3 speed car I parted out.

Regards,
Logged
Jim

1965 Skylark post car (65 GS frame 401/4-speed, 2x4's)
1964 Skylark (future 430 stick)
1965 Special 4 door 300 4speed
1964 Special 2 door (future, GS 401 3 speed stick)

Offline schlepcar

  • Crazy about Buick!
  • *****
  • Posts: 677
Re: Clutch linkage questions
« Reply #2 on: April 10, 2020, 03:43:15 PM »
Looks like you can just get a fine thread 3/8 die and thread it the rest of the way
Logged

Offline invicta65

  • Buick Fan
  • ***
  • Posts: 14
Re: Clutch linkage questions
« Reply #3 on: April 10, 2020, 04:18:45 PM »
The way it was adjusted before it was only threaded in 3/8”. I’m just making sure it’s not to short
Logged
1965 gran sport ht 3 speed
1968 skylark
Pages: [1]   Go Up
« previous next »