1964 Skylark/Special Radio face plate

[TrunkMonkey]

Looking for a radio plate, and do not need the bezel.

I will be refinishing it, and installing three 1-1/2" gages in it above the radio, where the A/C vent is located.

May also be interested in a 1965 plate and bezel if the price is not too steep.

Thanks,

Michael

[Loren At 65GS]

Have this one for a '65.

[JimL65]

There is one on Ebay

http://www.ebay.com/itm/112203367708?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

JimL

[cwmcobra]

There is one on Ebay

http://www.ebay.com/itm/112203367708?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

JimL

If that is the plate that Michael is looking for, I have one available in nice shape.  But I would defer to Loren, who responded first and probably has those available as well.  If he doesn't have any, I'll be glad to jump to the head of the line.

Chuck

[TrunkMonkey]

I was looking online at images of the 1965 bezel (last night) to try and figure out if there was a differnce between the years and actually found a complete 1965 bezel, plate, AC delete, radio and speaker!

So, I am set.

But, I do appreciate the responses, and I will keep the "line" protocol in case the larger plate (radio/speaker) is pitted badly. (hard to tell in pics, but I think it is just dirt and dust).


I'll post pics of it with the gauges mounted, as it will be a little while before I get the dash painted and stuff everything back in place.

Thank you all. 

[cwmcobra]

Thanks for the reply and, for sure, post pictures when you've completed the gauge panel.

Chuck

[Loren At 65GS]

Looking for a radio plate, and do not need the bezel.

I will be refinishing it, and installing three 1-1/2" gages in it above the radio, where the A/C vent is located.

May also be interested in a 1965 plate and bezel if the price is not too steep.

Thanks,

Michael

 Sounds like you are planing something along this line. Here is a picture of a setup I did in one of my cars, many years ago.
I made a template from card stock so I could determine the angles I needed. It is fabricated from sheet metal, bent and welded. Then covered with a vinyl similar to the grain on the dash panel.

 Loren

[TrunkMonkey]

Yes.

These 1-1/2 inch clocks.