Day 2 of assembly, went better that I thought it would. Both doors on pass fit good drivers, needs a little more adjusting and the door striker need a thinner washer and I did not have on over here. Both fenders prepped and the aprons put on the inner fenders, works much better with 2 people, and used a welding c clamp with a flat end, worked good. Pass fender installed with the inner attached, this is the most difficult fender to install because of the heater, it helps to swing the saddle out on that side and get the back of the fender kinda in place and then slide the saddle back. This fender was not on the car, it was a NOS one, even with this , I wish we had pre fit it, needed more shims and some adjusting and it will be OK but far from perfect. Wed we will attempt to finish adjusting the deck lid with the extensions on and re adjust the drivers door and finish the pass fender and tackle the drivers fender, and install the hood and do the final alignment, but that may run into Thru. Thanks Bill.