65GS.com - Buick Gran Sport Enthusiasts!

General Discussion => Q & A => Topic started by: invicta65 on April 10, 2020, 12:21:43 PM

Title: Clutch linkage questions
Post by: invicta65 on April 10, 2020, 12:21:43 PM

does anyone have close up pictures of the linkage parts and the length of of the adjuster parts. Need to know the the length of the threaded rod.

Title: Re: Clutch linkage questions
Post by: jmos4 on April 10, 2020, 03:34:15 PM

Hi,

I  get approximately 2-1/2-3" round section or 3-1/2-4" from hole, this was going from a bent one from a 3 speed car I parted out.

Regards,

Title: Re: Clutch linkage questions
Post by: schlepcar on April 10, 2020, 03:43:15 PM

Looks like you can just get a fine thread 3/8 die and thread it the rest of the way

Title: Re: Clutch linkage questions
Post by: invicta65 on April 10, 2020, 04:18:45 PM

The way it was adjusted before it was only threaded in 3/8”. I’m just making sure it’s not to short