65GS.com - Buick Gran Sport Enthusiasts!

General Discussion => Q & A => Topic started by: 35chevcoupe on February 06, 2018, 07:29:00 PM

Title: clutch rod adjuster length needed please
Post by: 35chevcoupe on February 06, 2018, 07:29:00 PM

Does someone have or know how long the clutch rod clevis ( approximate )  length is ?  ( clevis pin hole to clevis pin hole )
I bought these parts because I could not find a good complete one . So i,m planning to make one good clevis assembly out of the two but would like to know the approximate length that its suppose to be before I get it all welded up .

Title: Re: clutch rod adjuster length needed please
Post by: schlepcar on February 06, 2018, 08:34:22 PM

You can make one with the parts you have by using the top piece and drilling out the left Clevis and using a fine thread bolt in place of what is there.

Title: Re: clutch rod adjuster length needed please
Post by: 35chevcoupe on February 06, 2018, 10:01:03 PM

Dan , Thats my plan exactly .  But i need to know how long the threaded part is and my car isn,t as far along as yours is . I,m sending a bunch of parts out to get grey phosphate coated and was hoping to do it all in one shipment .
Thanks for the photo though , I might be able to figure it out by looking at yours .