65GS.com - Buick Gran Sport Enthusiasts!
General Discussion => Q & A => Topic started by: bobbybuick on November 13, 2013, 05:28:09 PM
-
Out of this entire restore the absolute hardest thing I have done is the trim around the doors and QTR windows.Also OPGI sent all the incorrect belt moldings.
Question on the trim that goes around the deck rear window.3 PC where do the studs that screw Vs the push in fasteners go anyone have a photo or wher to get the fasteners
-
I'll get some pics posted tonight.
Mark
-
Mark thanks is your a post window i have some questions about the windows also
-
Bob, mine is not a post car.
Mark
-
Is that called the Halo trim?just wanting to know how many and where the fasteners with the nuts go
-
Not "halo" trim, that is Skylark - not GS. I need to upload the pictures... tonight.
Mark
-
Mark I think I got it i used a nut on all the fasteners of the strraight piece and I think I can get to them all on the backside
-
The push in fasteners go on the C-pillar trim pieces. There is a trim clip with nut that go in all the holes
under the back window. Does that help?
Mark
-
The push in fasteners go on the C-pillar trim pieces. There is a trim clip with nut that go in all the holes
under the back window. Does that help?
Mark
Yes it does Mark and Thank you so much that is what I did
-
I know I'll probably get frowned at for this but I've been wondering how one would look without that particular piece of trim installed. Of course the holes would have to filled.
Dwaine
-
I know I'll probably get frowned at for this but I've been wondering how one would look without that particular piece of trim installed. Of course the holes would have to filled.
Dwaine
Dwaine I think it would look better IMHO however that trim piece says GS and my car is a low mile numbers matching car so the trim went back on
-
I have seen two 65 Gran Sports that did not have that trim. Both were CA cars. See http://65gs.com/board/index.php/topic,1396.0.html (http://65gs.com/board/index.php/topic,1396.0.html) for pictures.