65GS.com - Buick Gran Sport Enthusiasts!

Classifieds => Parts For Sale => Topic started by: bobbybuick on July 05, 2012, 10:03:59 PM

Title: 65 GS POST PARTING OUT
Post by: bobbybuick on July 05, 2012, 10:03:59 PM

I have 2 cars making one (Thin Pillar)
Rear seat frame upholstery shot 75.00
Front grill some pitting driver quality (not broken will clean up)with headlight bezels 100.00( i don't need 3)
driver GS fender couple dents surface rust only 125.00
Pass skylark fender hole in bottom been repaired but need redone 50.00
Pass door trim skylark 10.00
skylark fender emblems driver 20.00 both
rear taillights lens good pitted 175.00
I also have some rusted fenders doors for free(dayton Ohio) and a couple of core supports one is for a 67 if someone needs a patch panel
email me with needs  bobbybuick@sbcglobal.net

Title: Re: 65 GS POST PARTING OUT
Post by: WkillGS on July 06, 2012, 05:32:26 PM

Here's a tip....
Those rusted front fenders can be used to patch a rusted rear quarter wheelwell lip. :idea1:

Title: Re: 65 GS POST PARTING OUT
Post by: Mark Ascher on July 06, 2012, 05:36:26 PM

Hey Bobby,

Can you send me a couple of pics of the $50 rf fender, especially the lower section - inside & outside.
If you could send me a pm, I'll give you my email address.
Thanks!

Mark

Title: Re: 65 GS POST PARTING OUT
Post by: Shy lark on December 10, 2012, 09:35:32 AM

YOU HAVE ANY QUARTER PANELS FOR SALE NEED BOTH SIDES

Title: Re: 65 GS POST PARTING OUT
Post by: bobbybuick on December 10, 2012, 05:38:35 PM

im using the right side and it is rough i will have the drivers side but it is rusted around the wheelwell and back lower