65GS.com - Buick Gran Sport Enthusiasts!
Classifieds => Cars Wanted => Topic started by: 35chevcoupe on August 29, 2015, 09:28:10 PM
-
I,m looking to buy a factory 3 speed shifter for my 65 GS . Also need the radiator X braces . there is a set of X braces on Ebay for 115.00 but would rather have the $$$$ go to someone here on the 65 site .
let me know what you have ...
-
Are the braces the same on a 66GS?
-
good question Jim , let me do some checking .
If they are does that mean you have a set ?
Jim , from what I'm seeing the 64 and 65 are the same but i,m not sure about 66 .
maybe someone else can help us out on this :dontknow:
-
Cross braces are different all three years! 64's are straight
These were used in early 65 on downflow radiator cars , not
GS's as they are crossflow.65's have a bump out to clear the
Center hood latch brace.66's are straight and short as they
Go to different points on the core support!
-
Thanks gssizzler , I wasnt sure .
-
.do these look right? should be ....threads need chased but blasted and painted matte Black,will NEED Top Coated
i can check length if you like but these are off my spare 65 $60 plus shipping will be 10-15 dollars im afraid
-
Bobby does your spare car have AC?
I seem to recall that AC cars used a brace with a bow at the bottom for condenser clearance.
-
Bobby does your spare car have AC?
I seem to recall that AC cars used a brace with a bow at the bottom for condenser clearance.
No neither had AC but both ha the bow in the X Brace
-
All the GS cars had the x braces with the bow. Skylarks were straight.
Mark
-
Just noticed that I posted this under cars wanted instead of parts wanted .
:BangHead:
Bobbybuick are the threads on the one rod strong enough to hold ? ( they look a little rotted )
shoot me a price , if nothing else i can repair the end .
-
Just noticed that I posted this under cars wanted instead of parts wanted .
:BangHead:
Bobbybuick are the threads on the one rod strong enough to hold ? ( they look a little rotted )
shoot me a price , if nothing else i can repair the end .
you could just rethread them it looks like there is enough there to me .i posted the price below 60 plus shipping
-
OK , i,ll take them .
send me a pm on the total and how you would like to get paid .
Thank you .
-
Still need a 3 speed shifter and linkage
-
just paypal me the 60 it will have the address attached and i will print a label to get you the shipping balance
Just noticed that I posted this under cars wanted instead of parts wanted .
:BangHead:
Bobbybuick are the threads on the one rod strong enough to hold ? ( they look a little rotted )
shoot me a price , if nothing else i can repair the end .
you could just rethread them it looks like there is enough there to me .i posted the price below 60 plus shipping
-
bobbybuick pm sent .
-
Still need a 3 speed shifter and linkage
I have a Hurst 3 speed out of my GS, maybe the rods too. You can have it. I will try to dig it out, maybe you can use some or all of it.
-
i went ahead and threaded them both shipping monday 9405 5096 9993 9219 0377 15
-
Jim ,
I need to get my butt in gear and get down there . only time I will be out of town in sept. will be for the Jefferson swapmeet .
So maybe i can get figure out a time when we can meet up .
If I know enough in advance maybe I can pickup another Buick GS guy for the trip down . :glasses9: