65GS.com - Buick Gran Sport Enthusiasts!
General Discussion => Q & A => Topic started by: 35chevcoupe on November 07, 2016, 11:36:07 PM
-
I,m getting my 1st batch of parts ready to go to the chrome shop and was wondering how striped down the parts have to be .
For example the back up lamp housings , do the threaded studs need to come out and the bulb socket ? or do does just the wiring need to come off .
-
Hi,
I never had backup lights, but did have a set of backup deletes rechromed, I removed the studs.
If you haven't already gotten a quote I will fore warn you die cast parts like the backup light housing can be expensive as they have to drill out each pit and silver solder each one, so a nicer core will cost you less.
My deletes cost me 200 bucks each, I had a second set with more pits and they quoted me 500 a piece.
As for the light sockets not sure how they come out, but check with your plater and they should tell you what to leave or remove.
Regards,
-
Thanks Jim ,
The bulb socket i,m thinking is not removable with out destroying it . I tried a little bit to take out the studs but they seemed like they were in there pretty tight . I didn't try real hard though as I didn,t want to break them . Might try it again .
Ufda 200.00 each is kinda pricy .
I can only IMAGINE what my tail light housings are gonna cost . :sad4:
-
do the threaded studs need to come out and the bulb socket ?
A good chrome shop can put shrink tube over the threads - I didn't remove mine. I recommend Chrome Plating Indiana.
Thanks