To anyone interested. I will do anything, just about, to satisfy everyone's needs. If you just send all the nec. parts to make a complete assembly you will receive a complete assembly ready to bolt-on. I will need 8 stands in good condition. Some wear is OK as "My Rockers" are larger in this area over the stockers. This gives more contact area & even provides "More" oil for better lubrication in this area. Not wanted are "Rebuilt" stands. These are just ground down & made thinner for a "New" surface for the stock rockers. 4ea. of the flat & wavy washers. 4 short & 2 long spacer springs for a total of 22 pieces. Or, you can send your complete old, original assemblies & I will dis-assemble, clean & re-assemble. I will include the cotter pins. LOL. All of this at N.C. I can give to anyone at least a thread to follow in your quest to make YOUR NAILHEAD A BETTER NAILHEAD!!!!!! I basically know where to get ALL the parts & many of them I have or am having made. Flexplates will be coming soon. Now you don't have to search E-Bay any longer for a used flexplate that was dragged behind an engine at the yard or garage & in the pictures doesn't show it as being bent or the pictures only show the good "Teeth". I don't have any extra rocker parts on hand other than used rockers or shafts that others have sent & not wanted back. I have given much free advice as to what I feel are the common mistakes in building our "Nails". Also offer advice to "Improve" what you have or will be building. Walt will have to do some more checking of what I PM'd him about. My main quest is to see that EVERYONE gets out of their "Nail" as much as or more than they can expect or be expected. The performance of these engines are not being held back as some may believe. THEY CAN PERFORM!!!!!!!! I just hope that Edelbrock WILL come out with heads. Hopefully they will also be able to supply the proper head gaskets with the heads. Can't use shim steel on an aluminum head & can't use old technology composite gaskets with the dissimilarity of cast & aluminum. And as Walt has stated, "I would rather a call that type". This has taken me over an hour for this short message.
Tom T.