Good thought Chuck. I might be in for one too. Believe Loren has to confirm that the grain is correct yet. Also, for each pad over the initial 12 believe we all get a discount because the next batch would have a lower cost per pad.
Is the above correct Loren ?
Dan
Yes, it is correct that the cost would go down.
There is a sizeable cost to making the mold and the initial run is bearing that cost. In regards to end cost per pad, it would depend on the total count of the initial run. As it stands the price is for an initial 12 pads. One or two more may not have a significant change in that price.
I've been told DPP has 3 different grains of vinyl. I received a sample of one of the vinyl on Tuesday. The grain is not correct and I have already spoken to them about it.
As a result, I removed a section of vinyl from one of my pads and sent it to DPP. Waiting to hear back on that.
Lastly, expected time frame would be approximately 3 months once the actual project is started. There is also the details in regards to getting the cores and payment to DPP to work out.
Presently that is all the information I have.
Hoping this project will continue and I have not created false hope,
Loren