Reveal Moulding

[Dr Frankenbuick]

Looking for the driver side moulding for a hard top on the door. It is at the bottom of the window on the outside of the car.


Sent from my iPhone using Tapatalk

[dsags]

Is it the wide molding ? They made two kinds. The wide one goes with the wheel well moldings. Anodized aluminum.

Dan

[Dr Frankenbuick]

I think they are about 3/4 inch wide.  I attached a few pictures of the part and the good one from the other side.  I am in NE PA BTW.  I am looking for driver quality - not nos.  I think the complete set is available reproduced, but the other three pieces are fine.

Mine is ripped in half, but the right guy might be able to fix it.  I would not even know where to start looking fore someone like that?

[Loren At 65GS]

I have one odd one out in the storage area. I don't remember which side though.

I'll take a look.

 Loren

[dsags]

Let's hope Loren finds one that you need. Looked at mine and have a pair only. And they need to be anodized.

Dan

[Dr Frankenbuick]

Crossing my fingers - thanks guys!


Sent from my iPhone using Tapatalk

[gs spoken here]

Has anyone used the reproductions for a hardtop, I see them at Ames Pontiac, for 65/66/7? They rate the quality as good. Thanks Bill.

[Loren At 65GS]

Crossing my fingers - thanks guys!


Sent from my iPhone using Tapatalk

Sent you an email with pictures.

  Loren