« previous next »
Pages: [1]   Go Down

Author Topic: Where does this shield go??  (Read 596 times)

0 Members and 2 Guests are viewing this topic.

Offline gearhead46

  • Crazy about Buick!
  • *****
  • Posts: 53
Where does this shield go??
« on: September 03, 2015, 08:30:25 PM »
I've had my 65GS apart for a few years and getting back into it.  Making major progress after sitting idle for a while.

I have this part left over and, for the life of me, I can't figure out where it goes.  Can anyone give me some sage advice?  Sure would appreciate it.

Logged
Professor Gearhead
65 Gran Sport Sport Coupe
57 Buick Special 2 dr Hardtop
57 Buick Roadmaster Convertible

Offline Mark Ascher

  • Administrator
  • Crazy about Buick!
  • *****
  • Posts: 1615
Re: Where does this shield go??
« Reply #1 on: September 03, 2015, 09:11:15 PM »
Inner fender, engine compartment side. You'll see the two bolt holes if you peek inside the inner fender.
Toward the back. I think that one is the right (pass) side. The bottom curved part follows the contour of
The frame.

Mark
« Last Edit: September 03, 2015, 09:13:45 PM by Mark Ascher »
Logged
65 GS HT 4 Speed - BCA Senior 2015; AACA Senior Grand National 2021
66 Impala 396/TH400/12 Bolt "Project Rodent Remediation" - Almost Done
69 Bel Air 2 Door Sedan "Project Junior Stock" - In Process
19 Chev Silverado Pickem Up (daily driver)

Offline gearhead46

  • Crazy about Buick!
  • *****
  • Posts: 53
Re: Where does this shield go??
« Reply #2 on: September 03, 2015, 09:40:27 PM »
Got it!!!  Thank  you, my man!!
Logged
Professor Gearhead
65 Gran Sport Sport Coupe
57 Buick Special 2 dr Hardtop
57 Buick Roadmaster Convertible
Pages: [1]   Go Up
« previous next »