Author Topic: Z-bar platic bushing for 66 Skylark GS 4 speed  (Read 1274 times)

0 Members and 1 Guest are viewing this topic.

Offline gs spoken here

  • Crazy about Buick!
  • *****
  • Posts: 376
Z-bar platic bushing for 66 Skylark GS 4 speed
« on: November 25, 2014, 09:27:19 PM »
I seen the post on the upper bushing from Corvette, for replacement on the clutch rod end of the Z-bar, anyone found a replacement for the plastic bushings for the shaft. See pictures of mine, one kinda came apart when I removed it. Thanks Bill.

Offline Mark Ascher

  • Administrator
  • Crazy about Buick!
  • *****
  • Posts: 1615
Re: Z-bar platic bushing for 66 Skylark GS 4 speed
« Reply #1 on: November 26, 2014, 09:28:00 AM »
Bill,

Those are available, I just don't remember where. Jon Thompson possibly?

Mark
65 GS HT 4 Speed - BCA Senior 2015; AACA Senior Grand National 2021
66 Impala 396/TH400/12 Bolt "Project Rodent Remediation" - Almost Done
69 Bel Air 2 Door Sedan "Project Junior Stock" - In Process
19 Chev Silverado Pickem Up (daily driver)

Offline gssizzler

  • Crazy about Buick!
  • *****
  • Posts: 901
Re: Z-bar platic bushing for 66 Skylark GS 4 speed
« Reply #2 on: November 28, 2014, 06:15:24 PM »
Bill, and others I still have some of the upper pivot lever arm, bushings that I had made , these fit the 3 and 4 speed gs cars plus 65 wildcat stick pedals they are $20 pair shipped thanks! Jon

Offline gs spoken here

  • Crazy about Buick!
  • *****
  • Posts: 376
Re: Z-bar platic bushing for 66 Skylark GS 4 speed
« Reply #3 on: November 30, 2014, 12:06:19 PM »
Jon, thanks for the call the other day. Yes I will send payment in a few days for the bushings. Thanks everyone.

Offline gs spoken here

  • Crazy about Buick!
  • *****
  • Posts: 376
Re: Z-bar platic bushing for 66 Skylark GS 4 speed
« Reply #4 on: January 18, 2015, 04:29:50 PM »
Jon, (gssizzler) received the upper clutch shaft bushings very nice, and I had to only clean the shaft and they slid right on, again Thanks.

Offline gssizzler

  • Crazy about Buick!
  • *****
  • Posts: 901
Re: Z-bar platic bushing for 66 Skylark GS 4 speed
« Reply #5 on: January 19, 2015, 12:04:42 AM »
Thanks! ,Bill and good luck with that 66! Can't wait to see it done!,hope to see you and many 65 GS members in Springfield! Been so busy with work ugh! ,making some progress on the post 3speed car, posi
Rear is almost done, brake booster and master ready to hook up,stick pedals restored and in,bucket seat brackets in lots more to go!  jon